1、在完成的表面上畫線，并標出每一列的位置。
        2、在柱使用電鉆，深度為50mm，底部的深度為100mm，與鋼柱的直徑的鉆頭直徑。
        3、用錘子在鉆柱上加固，柱鋼長度為柱高50（100）mm。
        4、花部通過柱加強。
        5、40mm×40mm×80mm、100mm正方形1區(qū)塊（40mm×100mm見方，間距和數(shù)量的放樣柱鋼筋鋸鑿木材長度差距），別墅鋁藝護欄，加固后的安置木材缺口，然后12線兩塊從臨時領(lǐng)帶夾柱木在50mm，那么整個柱間支撐校正。
        6、排在一個頂端，石墨打擊線，然后柱加強頂端削減傾斜表面吹氧。
        7、焊接平鐵別墅鋁藝護欄，其次是扁鐵彎曲、翹曲，使用乙炔加熱和冷卻水后校正，并矯正扁鐵。然后焊角為平鐵扶手兩端連接角的平鐵焊接后拆除領(lǐng)帶夾在頂部的木柱柱上加固。
        8、焊接附件。

1, on the surface of the finished line drawing, and mark the location of each column.

2, in the column using a drill, depth of 50 mm, at the bottom of the depth of 100 mm, and the diameter of the steel column is the diameter of the bit.

3, reinforced by a hammer on the drill string, high column steel length is 50 (100) mm.

4, flower department through the column.

5, 40 mm x 40 mm x 80 mm and 100 mm square 1 block (40 mm x 100 mm square, spacing and number of lofting column reinforced saw cut timber gap length), villa aluminum art guardrail, resettlement timber gap after reinforcement, then 12 line two pieces of wood from the temporary stickpin column in 50 mm, between the whole column support correction.

6, ranked at the top of the a graphite hit the line, and then the top of the column to strengthen cut inclined surface oxygen.

7, welding flat iron villa aluminum art guardrail, followed by flat iron bending, buckling, using acetylene correction after heating and cooling water, and correct any flat iron. Then weld Angle for the flat iron railings on both ends of connection Angle of flat iron welding after dismantling stickpin reinforced beams on the top of the column.

8, welding accessories.